Recent content by Shaun2007

🙂 nice one mate. I've just tried to upload another pic but it says too big. If necessary please send me an email address or WhatsApp number and I'll drone on at length, my poor mrs hates me for it.

Just found this amazing item on AliExpress. Check it out! ￡4.92 64%OFF | 1Box Mini Driving Light Spot Light Waterproof Hi&Low for Motorcycle Headlight LED Bulbs https://a.aliexpress.com/_EHeCQ5h This is as cheap as you can get them but they are really bright. Your going to have to mount them...

😃 yes of course, two minutes mate.

After a fair amount of messing about, Ebay led daytime running lights finally fitted. Quite bright, yellow and white depending on which beam you use on the bike. Really clever for what they cost, two led chips inside positioned to give a dip/high position on the road. My clever brother made the...

Ah, no worries mate but thank you for trying.

🙂 thank you sir, 2014

🙂 thank you for your reply. What I'm actually looking for is a drawing of the pin-out of the headlight power supply socket. Mine is detached, long story. There are four wires, brown=ground, white/green tracer=led daytime running, yellow=low beam, white=high beam. I just need to know which pin is...

Hi all, could really do with a favour please. Does anyone have a drawing of the headlight plug/socket that they can send me on here please? Thank you very much indeed 🙂

Very good 😃 I've been looking at the alternatives ref variator too. One thing that is interesting, apparently our scoots are mapped to only give proper welly beyond a certain mph to save the chain. This I must investigate 🤔

🤔 Half tuned, please tell me more lol.

Thank you for that mate 🙂 I'm really unsure what to do now as I'm sure mine still has the strainer.

Thank you very much, think I'm in the same position as you. Need to check next oil service. Seems a bizarre set up but well done on finding out the tube should have been fitted. May I ask how you found out? Thank you in advance, Shaun

Hi mate, did you manage to get to the bottom of this? Mine still has two strainer tubes fitted. Thank you.

Apologies in advance if this part has been covered before, I've looked around on here to try and make sure I'm not covering old ground. My 64 plate 650GT has always had a concerning rattle from the right side of the engine, sure enough, took it apart yesterday and I'm 100% sure the tensioner is...