Recent content by Msprygada

Yes, I installed the back rest and never removed my seat. The BMW was used by my wife and myself as a two up machine and we will continue to do that occasionally but I bought a Versys X300 as my ride and the BMW will now be my wife's ride and she is the one that needed the back rest as she has...

Yes you can remove the back rest without removing the seat. You just removed the three Torx bolts located in the circles (they are already removed). Takes like 30 seconds. The Arrow is pointing to the location of the back rest bracket bolt you will need to drill and install. Here is a...

I am just finishing up my support bracket to stiffen up the bracket and prevent unwanted flexing of the seat pan. I will post pictures when I have it finished.

I see that Carpuride has a BMW version of their CarPlay unit. Does anyone know if the BMW mount that is mounted on the bike able to be used or do they have one for a C400GT so you can use the wonder wheel?

Received my Utopia backrest on Saturday. Looks to be of pretty good quality. Like Strangecloud indicated, it took about 45 minutes to install. I did not have to remove the seat from the scooter. Here is where you have to cut the seat cover and drill a hole. The bracket on the bottom of the...

I have a question. It looks like all the modifications for this occur under the factory butt rest. Do you think that if you had to remove it that you would see it on the seat? I am getting this for my wife as she needs a back rest and I am kinda anal about how aftermarket mods could gorp up the...

Nevermind. Found a thread I responded to last year.

I would chase down installing the grips but the heated seat to me is a gimmick. I used to have a quad that I rode year round and I never recall having a cold butt even with temps into the teens. Plus when it's on, it's the same sensation to me that I get on a hot summer day (I think they call it...

Glad you like it. Enjoy your riding and keep the rubber side down.

Yup. It shakes a little bit but hell its mostly plastic up front so you can only make plastic so rigid. I am really happy with my set up.

Make sure to get the right mount size for the bar you are using. But it’s very high quality. I originally found one that was 3D printed but the problem was when you tightened it down, it would flex and then it was really hard to get the Garmin to snap into the mount. This one is aluminum and...

So did you use this SAE plug to be able to easily move the Garmin to another vehicle? Otherwise, the plug and wires are ugly. Maybe put window tint on the back side of the wind screen where it mounts to the scooter and then all you will see of the wires is through the vent. I tried to use the...

Hey Bill, I am going to assume that you got the coolant leak fixed???

Johng, can you provide a few pictures of your setup? Did you get the above or below set up?

I am looking to get cruise control and had the Kaoko on a prior motorcycle and found it annoying. Like Bill says, it’s hard to hand on to the throttle keeping it at a single speed and rotating the ring. I am looking at getting something that has a button like the atlas. Byee, did you actually...