Recent content by Norman

Thank you very much Steve I. Norman

Usually you can tell by the thicker cable running to the starter motor. Will have a look. I have to power the ECU, that I don't lose the wind shield move operation. Cost $ 100 AUD to resetting it.

I appreciate your reply. I will have a closer look....i thought it would sit closer to the starter motor. Meaning a lot of " plastic" has to be removed to check it. Many thanks, Norman

Hi Members, I'm looking for the starter relay location for my C650 GT K19. Help would be appreciated. Thanks Norman

40 x 68 x 15mm Sealed Ball Bearing (marked FAG 6008 2RSR). this is only one I replaced. The bearing place told me just to use a 6008 sealed bearing. The needle bearing I just greased with plenty of high temp bearing grease. The seals looked ok but I shorted the spring inside. Learnt that 50...

Thanks Steve, yes I took it apart and it was the bearing 6008. The hardest was to get the " bush" in front of the bearing off. It was/ is part of the needle bearing . Finally we got it off with heat applied. Running beautifully now. Thanks again Norman.

Just replaced mine. I forgot where I had the hint from, I think youtube. Anyway it said order 2x sets of grips so you have 2x 25mm. I bought mine from AliExpress $ 12.- each set. But I tell you it is not easy ( which you maybe found out already) Left side was not too bad; using a heatgun and...

Hi Members, I have a Question again; over the last few month I have like a " grinding" noise on my 2013 /50000km 650 GT.( specially when cold) After reading in the Forum that the rear bearings can sometimes give trouble. When it is on the centre stand, everything seems ok. The tyre/rim have...

Many thanks, Delray. You helped me out again. I would never thought that they are in the inside. I have a larger syringe and can use it, to reduce the fluid. I realise what brake fluid can do. Thanks ,Norman. I will do the new brake fluid as well, later.

Hi everyone, I bought mine (2014) 10 month ago with 46000 Km on it. The Brake pads ,front and rear looked worn, but the sight glass showed not even a " bubble". So the reservoir was full and there was also no upper marker on it . Do I have to reduce the brake fluid in the reservoir before I push...

Many thanks, for all the effort to explain things to me. I will look into it. You are right with install a new battery. Sometimes it works but most of the time not.

That $10.- was only labour I supplied the tyre. Sorry about the miss understanding

I went to a tyre place $ 10.- to take it off and 10.-to put the new one on. I guess I was lucky that the " computer" accepted the job so far. Of course it would be better what you have done.