Search results

C650GT Intermittent no crank and no brake light. On a few occasions this year I have been unable to get the bike to crank and therefore start. The second time this happened I noticed the rear brake light not working and was able to start the engine by operating the front brake. I judged the...

It is a Spherical bearing see: https://en.wikipedia.org/wiki/Spherical_bearing#Construction

I fitted a Skidmark Extena Fenda (Suzuki Burgman 2012+ item code 050453) in 2018 and have now further extended it. https://www.bmw-scooters.com/media/3-fender-extender-overview-jpg.312/

The side stand and brake switches inhibit cranking, so you have a fuel supply or spark issue.

My bike now has 42,000 miles (68000Km) on the clock. During the last few years our annual trip round Spain has been marred by occasional overheating warnings from the bike. These occur when the bike is under heavy load at slow speed in temperatures above 30C (86F). The cooling system was...

A section of the wiring diagram you may find useful.

I actually ran my 2017 GT out of fuel to check, cruising with rider only it did 30 miles before stopping.

https://www.bmw-scooters.com/threads/fender-extender.2056/

I have used Copaslip on the silencer/exhaust pipe joint for the last 7 years without problems. It prevented corrosion and allowed the silencer to be removed and turned as required.

See: C600, C650GT Technical Water Pump 02 - Seal Replacement https://www.bmw-scooters.com/threads/water-pump-02-seal-replacement.2921/

See atached

BMW wiring diagrams are now available from: https://repairmanuals-download.com/product/wiring-diagrams-bmw-moto/

K22 is the Starter relay

C650 Wiring Diagrams I have a dip beam lamp warning my 2017 C650 GT and this has not been resolved by changing the bulb, after searching the workshop service DVD l am unable to find any electrical circuit diagrams. In Europe these seem to be only available with a professional service tool and...

The bearings are pre-lubed. Some info on the "ARS" bearing suffix is below and a photo of my spares.

Hi Norman, As far as I know the Mk1 and Mk2 bearings are the same but the crush drive/rear sprocket is different, the Mk2 does not have the rubbers. The last time my rear wheel bearings failed, the symptom was vibration from the seat and footboards at 50mph. The notchy bearing had caused the...

The right (battery) side fork leg removal requires the air intake to be moved up. Loosen the rear bolt and unclip the front rubber mount. I found a T45 x 200mm bit was needed to remove the lower pinch bolts due to the restricted space. See photos. The pinch bolts are fitted with Blue Loctite...

I use this

What do you mean by "front strainer" The only oil strainer is in the bottom of the oil tank and it is cleaned, not removed. See attached.

See also: C600, C650GT Technical / Water Pump 02 - Seal Replacement During this years trip round Spain I noticed a few drops of coolant under the bike, as the levels were OK I choose to investigate the issue on my return to the UK. I checked the pump first by removing the 2 bolts underneath...