Recent content by jorgebri60

Soooo, did you ever get the Denali taillights to work @Butch Sweaters ?

I love it, and yes I would buy again. The backrest pad took a while to get in, but other than that, it’s been a great addition to the scooter. I have not added the brake light yet. I’ll get to it eventually.

Here you go!

Here you go.

70+ MPH does eat up your battery at a significant pace, but you should be fine. I'd carry the charger with me if you want to run more around. I can go all day with a full charge when I use it for work. For me, it's 12 miles each way with either 5 or 8 miles at 70+, but I typically do some more...

Sorry, just catching up on this forum.. I'll post some later tonight when I get home. I'm on the GSA today :D

I have this exact setup. Works great, install was easy. When I get home today I'll post a picture

This light will have to be spliced. On top of that, because of the design of the CE04, I’ll have to route the wires back to mid frame where the swing arm pivots and back via the same route the factory cables use. Basically , im going to have to extend the supplied harness.

Greetings all. I installed a shad SH47 on my CE04, and I purchased a brake light kit to go with it. Being that this bike is so electronics sensitive, anyone know of or have knowledge of whether or not a can splice into the rear brake light on the Scooter? Thank you

It's been a while since I sold my GT, but it's relatively easy to re-upholster a seat. That or you can do what I did, get yourself a Corbin Heated seat. It made a world of difference for me. Good luck

I've since sold my scooter, but I had that same "rattle" when I had mine. It would go away once the bike ran a few miles (warm-up) and yes, it sounded like the valve lifters needed adjusting. It sometimes sounded even worse, like piston slap or even a rod that was flopping around. It always...

Morning folks, Trying to see if there is any interest in a set of Sena 30k bluetooth helmet audio systems. I used one of them a few times throughout one year the other still in the box. I've sold the scoot and have them laying around so thought I'd try and see if anyone needs a set. These cost...

Yes. Just a 30-40 seconds should do.

My 2016 used to do that if I didn't let it warm up a few seconds. Just easing off the throttle a bit and slowly applying it got me going and after a minute or so it would be fine.

I've put this on my last 2 bikes (650gt included). While not electronic, better than nothing and really good for resting your right hand. https://www.amazon.com/gp/product/B018JS7C8M/ref=ppx_yo_dt_b_asin_title_o03_s00?ie=UTF8&psc=1